= Compressed Caching = = For 2.6.x kernels = === Nitin Gupta === ---- This page gives all the details collected together for compressed cache implementation. Many of the ideas have been taken from Rodrigo’s work and this paper: Adaptive Main Memory Compression by Irina Chihaia, Thomas Gross. Here I will keep track of project progress. Please add any suggestions you have or edit anything you find incorrect. ---- == Introduction == Compressed caching is the introduction of new layer in virtual memory hierarchy -- Compressed Cache. It compresses and stores pages that would otherwise have been swapped to slow disks or freed under memory pressure. This effectively increases RAM space and avoids /reduces accesses to slow disks. This basically takes advantage to rapidly increasing CPU power, faster, lower latency memories and sluggish hard-disk speed improvements. == Work Done == Currently the implementation simply replaces a page with a copy of itself (i.e. no actual compression yet) and replaces its reference in page cache with a ‘chunk_head’ (all this is detailed below). On page cache lookup, the original page is obtained by again copying and setting corresponding page cache entry back to this page instead of ‘chunk_head’. Also, one of compression algorithm (WKdm) has been ported to kernel space. The idea is to first have a framework ready for further implementation and gain more familiarity with VMM code. == General Background == The system maintains two LRU lists – active and inactive LRU lists. These lists may contain both page-cache (file backed) and swap-cache (anonymous) pages. When under memory pressure, pages in inactive list are freed as: * Swap-cache pages are written out to swap disksusing ‘swapper_space’ writepage() (swap_writepage()). * Dirty page-cache pages are flushed to filesystemdisks using filesystem specific writepage(). * Clean page-cache pages are simply freed. For compressed cache to be effective, it needs to store both swap-cache and page-cache (clean and dirty) pages. So, a way is needed to transparently (i.e. changes should be required within VMM subsystem only) take these pages in/out of compressed cache. == About Page Cache == Please see: http://www.linuxsymposium.org/2005/linuxsymposium_procv2.pdf -- paper ‘Examining Linux 2.6 Page-Cache Performance’. Each open file has a separate radix tree to maintain its pages in page cache. So, in effect, each open file has its own page cache. The offset within the file is used as key to locate the corresponding page in memory. == About Swap Cache == All swap cache pages are part of a singleswapper_space – a single radix tree maintains all pages in the swap cache.swp_entry_t is used as a key to locate the corresponding pages in memory. attachment:SwapCacheEntry.jpg type identifies things we can swap to. == During Swap-Out == shrink_cache() prepares a list of pages to be freed (these pages are from inactive list) and hands over this list to shrink_list() which then tries to free pages in the list, a page at-a-time handling swap-cache pages and (clean/dirty) page-cache pages as above. attachment:ShrinkCache.jpg attachment:ShrinkList.jpg == During Swap-In == If page is anonymous, '''do_swap_page()''' looks-up swap cache first (using swp_entry_t stored in pte as key), if not in swap cache the required page is read in from swap disk (with some readahead), added to swap cache and the page is returned (mapped to process’ VMA). For file-backed pages same logic applies ('''do_file_page()'''): If page is file backed, page cache is looked up first (usingoffset within file stored in pte as key), if not in page cache the requiredpage is read in from filesystem disk (with some readahead), added to page cacheand returned (mapped to process’ VMA). attachment:HandleFault.jpg